When starting the WF series generator set, in order to ensure safe and efficient operation, the following aspects need to be noted:
1、 Check before starting WF series generator set
Appearance inspection:
Confirm that the appearance of the WF series generator set is intact, with no obvious damage or deformation.
Oil and coolant inspection:
Ensure that the oil level is between the upper and lower limits of the dipstick, and replenish it promptly if it is insufficient.
Fuel inspection:
Confirm that the fuel tank has sufficient fuel and that there are no leaks in the fuel lines. If the fuel filter element needs to be replaced, it should be replaced according to the specified time.
WF series generator set battery inspection:
Check if the battery voltage is normal, usually above 12V.
Inspection of connecting components:
Confirm that all connecting components of the generator are securely fastened, including belts, fasteners, etc.
Surrounding environment inspection:
Ensure that there are no debris, obstacles, and good ventilation around the WF series generator set.
2、 WF series generator set startup steps
Turn on the control screen power:
Turn on the power supply of the control screen and check if the idle rated switch is in the idle position.
Set startup mode:
Set the control screen operation buttons to Manual mode.
Start the generator:
Press the green start button to start the generator.
Observe the start-up process of the Weifang series generator set. If there is any abnormal sound or vibration, stop the machine immediately for inspection.
Check the status after startup:
Confirm if the idle speed, voltage, frequency, and battery voltage are normal. Check that there are no warning phenomena in the water temperature, oil pressure, and fuel level detection systems.
Adjust to rated speed:
After confirming that the idle speed is correct, turn the switch to the rated speed position. Observe whether the RPM value of the idle and rated speed of the unit is normal. Check if the generator voltage, frequency, and battery voltage are normal at the rated speed of the unit.
Load and run:
After confirming the accuracy, click the WF series generator set load on/off button to close the circuit. Check if the automatic switch for closing is turned on. Load the electrical equipment in order of power, from highest to lowest.
3、 WF series generator set safety precautions
Comply with safety regulations:
When operating the generator, safety operating procedures should be followed and protective equipment such as gloves, earplugs, etc. should be worn.
Prohibit illegal operations:
It is prohibited to carry out any maintenance or inspection work during the operation of Weifang series generator sets. Overloading the generator is prohibited to avoid damaging the equipment.
Before setting the WF series generator, it is necessary to conduct a check to ensure that all conditions meet the startup requirements; During the startup process, strictly follow the steps and pay attention to monitoring various parameters; After startup, it is necessary to strengthen monitoring and maintenance to ensure the safe operation of the equipment.
More information on WF series generator sets:https://fadianjipower.com/
